Scroll chiller manufacturer in India

Scroll Chillers

Compact, quiet and efficient scroll chillers for machine-side and small-plant process cooling: 5 to 90 TR, air cooled or water cooled.

Scroll chillers are the default for light and medium process loads: an injection moulding machine, a laser, a printing line, a lab or a small plant. They are compact, quick to install and simple to maintain. Teqtive builds them in air cooled and water cooled versions with shell-and-tube or brazed plate evaporators.

Teqtive scroll chiller range

Teqtive rangeCapacityTemperatureBest for
Air cooled scroll chiller5 – 78 TR+25 °C to −10 °CPlug-and-play, no cooling tower
Water cooled scroll chiller5 – 90 TR+25 °C to −10 °CIndoor installation, lower power

How a scroll compressor works

Two interleaved spirals form crescent-shaped pockets. One spiral is fixed; the other orbits without rotating. Gas enters at the outside edge, is trapped in a pocket, and is pushed toward the centre as the pocket shrinks, leaving through a discharge port at the middle. Several pockets compress at once, so the flow is smooth and nearly pulse-free. With no valves and few moving parts, scrolls are reliable and quiet.

Where scroll chillers fit best

  • Injection & blow moulding
  • Extrusion lines
  • Printing & packaging
  • Lasers & machine tools
  • Labs & pilot plants
  • Food & beverage process water
  • Hydraulic circuits
  • Small brewery & dairy glycol

Scroll, screw or reciprocating?

ScrollScrewReciprocating
Typical chiller size5 – 90 TR40 – 500 TR1 – 120 TR
Lowest practical temperatureabout −10 °C−10 °C (−40 °C as brine chiller)−35 °C to −40 °C
Capacity controlCompressor stagingSlide valve, VFD, stagingCylinder unloading, staging
Noise and vibrationLowLowHigher
StrengthCost and efficiency at small sizesLarge continuous loadsLow temperature in small sizes

Full comparison: screw vs scroll chiller. For large loads see screw chillers; for sub-zero duty see brine chillers and reciprocating chillers.

Sizing a scroll chiller for a machine

Most moulding machines need roughly 0.1 to 0.15 TR per kg/h of throughput for mould and oil cooling together, depending on the polymer; many machine makers state the heat to be removed in kW, which you divide by 3.517 for TR. Size for your summer design ambient, typically 45 °C for air cooled units in north India. The tonnage calculator covers the method, and the plastics industry page covers moulding duties in detail.

Frequently asked questions

What is a scroll chiller?

A scroll chiller uses scroll compressors, in which one spiral orbits inside a fixed spiral and squeezes refrigerant gas toward the centre. Scroll compressors are hermetic, have very few moving parts and run quietly, which suits them to chillers from about 5 TR to 90 TR.

What sizes do Teqtive scroll chillers come in?

Air cooled scroll chillers from 5 to 78 TR and water cooled scroll chillers from 5 to 90 TR, for chilled water or glycol from +25 °C down to −10 °C.

Why do scroll chillers use several compressors?

Each scroll compressor is a fixed-speed, fixed-size unit, so larger chillers combine two, three or more in tandem or trio sets. Switching compressors on and off gives stepped capacity control and keeps the chiller running if one compressor fails.

When should I choose a screw chiller instead?

Above about 60–80 TR, or for heavy continuous loads, a screw chiller usually gives lower cost per TR and better full-load efficiency. Below that, scroll is normally more economical.